Plastic Mold for 3D Panels Plaster wall stone 3D decor wall panel PAD 1Pcs Mold

Description

PAD
Form for the manufacture of 3d panels
PAD
3d tile is universal for interior and exterior. It can be used for finishing walls, ceilings, columns and other architectural structures. Wall panels made of gypsum will make your interior individual and refined.
At us you can buy forms from ABS plastic and independently make 3d panels from gypsum or concrete.
How to make 3d panels?
1. Not necessary (but recommended). Make a frame (wooden is ok) under the mold so that you can tightly fix your mold on the surface.
2. Lubricate the mold (especially in deep places and corners). You can use special greases or something like vaseline (petrolatum).
3. Make mixture with ratio shown in the spreadsheet at the top and fill the mold. Tap the mold slightly several times to remove air from mixture.
4. After about 3-5 min you can feel that plaster got warmer, after this wait about 15 min and bend the edges one by one, carefully turn the mold upside down and take it off from panel.
5. Look at the panel edges and remove bevels with putty knife if they appeared.
6. Leave panel to dry in a warm place (face side down or in vertical position).
7. Also you can already mount them on wall without waiting for drying because gypsum does not shrink.
Form characteristics
Size: 21.7x21.7 in (550x550mm)
Weight: 1.2 lb (0,55kg)
Material: ABS plastic
Number of fills: 200+
We recommend using gypsum for casting G-10, G-15, G-16, the ratio of 4.4lb (2 kg) of gypsum to 1 liter of water.
Finished panel parameters:
The size is 19.7x20.9 in. (500x530mm)
Thickness of the product 0.4-0.8 in (10-20 mm)
The area of 1 panel is 387 in² (0.25 м²)
The approximate consumption of gypsum for 1 panels is 8.8-13.2 lb / pc. (4-6 kg/1pcs)